Appendix C IPv6
GS1920v2 Series User’s Guide
465
Example – Enabling IPv6 on Windows 10
Windows 10 supports IPv6 by default. DHCPv6 is enabled when you enable IPv6 on a Windows 10 PC.
To enable IPv6 in Windows 10:
1 Select Control Panel > Network and Sharing Center.
2 On the left side of the Network and Sharing Center, select Change adapter settings.
3 Right-click your network connection and select Properties.
4 Select the Internet Protocol Version 6 (TCP/IPv6) check box to enable it.
5 Click OK to save the changes for the selected network adapter.
6 Click OK to exit the selected network adapter Properties screen.
Example – Enabling DHCPv6 on Windows 10
Windows 10 supports DHCPv6 by default. To enable DHCPv6 client on your computer:
1 Select Start > Settings > Network & Internet.
2 On the left side of the Network & Internet, select Ethernet. Then select the Ethernet network you are
connected to.
3 Under IP assignment, select Edit.
4 Under Edit IP settings, select Automatic (DHCP) or Manual. Then click Save.
To Next Page
Loading...
