ABB ACL30 - Page 254

254 Parameters
51
51 FBA SETTINGS
Further fieldbus communication configuration. These
parameters need to be set only if a fieldbus adapter
module is installed.
51.01 FBA TYPE
Shows the fieldbus protocol on the basis of the
adapter module installed.
0 / UINT32
PROFIBUS-DP 0
CANOpen 1
DEVICENET 2
ETHERNET 3
PROFInet IO 4
EtherCAT 5
ETH Pwrlink 6
RS-485 COMM 7
MACRO 8
SERCOS 9
51.02 FBA PAR2
Parameters 51.02…51.26 are adapter module-
specific.
For more information, see the User’s manual of the
fieldbus adapter module. Note that not all of these
parameters are necessarily used.
- / UINT32
... ...
... ...
51.26 FBA PAR26
See parameter 51.02 FBA PAR2. - / UINT32
0...65535
1 = 1
51.27 FBA PAR
REFRESH
Validates any changed adapter module configuration
parameter settings. After refreshing, the value
reverts automatically to DONE.
Note: This parameter cannot be changed while the
drive is running.
DONE /
UINT32
DONE Refreshing done. 0
REFRESH Refreshing. 1
51.28 PAR TABLE VER
Shows the parameter table revision of the fieldbus
adapter module mapping file stored in the memory of
the drive.
In format xyz, where x = major revision number; y =
minor revision number; z = correction number.
- / UINT32
0x0000...0xFFFF
Parameter table revision. 1 = 1 / -
No. Bit/Name/Value/
Range
Description Def/Type
FbEq
(16b/32b)