Accu-Chek Inform II

120
08424705001 (01) 2017-04 USA • Accu-Chek Inform II Operator’s Manual Version 6
1 Slide the base unit upward and remove it from the
wall mount (if in use).
2 Connect the power supply to the power input jack.
3 If you want to connect the Accu-Chek
Inform II Base Unit in a wired environment:
Connect the Ethernet (RJ45) cable or the USB cable
to the respective port. Use only the USB cable pro-
vided with the Accu-Chek Inform II system.
4 Slide the base unit back onto the wall mount (if in
use).
For details on configuring the Accu-Chek Inform II Base
Unit, contact Accu-Chek Customer Care for technical
assistance.
Note for System Administrator: For further technical
information on setting up and configuring the
Accu-Chek Inform II Base Unit, consult the package
insert accompanying the device and the “Technical
Note” stored on the Accu-Chek Inform II Base Unit as a
PDF file. You can access this file by connecting the base
unit to a PC with the USB cable.
For connecting the Base Unit with older hardware
(REF 05060290001), see Appendix F, “Appendix for
Accu-Chek Inform II Base Unit (legacy version)”.