Accu-Chek Inform II User Manual

76
08424705001 (01) 2017-04 USA • Accu-Chek Inform II Operator’s Manual Version 6
Confirming or selecting the test
strip lot
Once you have entered and confirmed the lot number of
the control solution, you are asked to choose the lot
number for the test strips. Compare the number dis-
played by the meter to the number on the label of the test
strip vial.
1 Select the lot number as follows:
■ To read the lot number from the test strip vial via
barcode scanner, press and release . Follow
the instructions for scanning IDs.
■ If you want to use the preselected lot number dis-
played by the meter, touch to confirm.
■ To use a different lot number than the one dis-
played, touch to open the keypad and enter
the number manually, or to display a list of stored
lot numbers and then select the desired lot number
from the list.
2 Touch to confirm the selected test strip lot
number.
For additional information about storing lot numbers for
test strips, see page 87.
The meter can be configured so that manual
confirmation is not necessary. In this setup, only the lot
number is displayed. Additional options are not availa-
ble.
The meter can be configured so that lot numbers are
entered via barcode scanner only.
The meter can be configured so that lot numbers can
only be selected from a list.
Control Test
Control L2 (Hi) 123456
Use Strip L
ot
12:48 pm
123456?
03/17/17
Strip Lots
344789
545794
545777
344654
12:48 pm
03/17/17

Accu-Chek Inform II Specifications

General

Sample Size	0.6 µL
Test Time	5 seconds
Memory Capacity	1000 test results
Display	LCD
Measurement Range	10 to 600 mg/dL
Connectivity	Infrared
Sample Type	Capillary whole blood
Operating Temperature	16 to 32°C (61 to 90°F)
Relative Humidity	10 to 90% non-condensing