Accu-Chek Inform II User Manual

78
08424705001 (01) 2017-04 USA • Accu-Chek Inform II Operator’s Manual Version 6
Applying the control solution Once the meter has checked the test strip, the hourglass
icon disappears and you are prompted to apply control
solution.
1 Wait until the flashing drop appears in the display
before applying the control solution. The meter
beeps.
2 Apply a drop of glucose control solution to the
front edge of the test strip. Do not apply the con-
trol solution to the top of the strip.
The control solution is pulled into the test strip by
capillary action.
Once sufficient control solution has been detected, the
meter beeps and the measurement begins.
Control Test
Control L2 (Hi) 123456
Strip L
ot 545794
12:48 pm
03/17/17
When applying the control solution, position the meter
so that the test strip port is always higher or on the
same level as the control solution. This prevents any
excess solution from flowing down the strip and enter-
ing the meter.

Accu-Chek Inform II Specifications

General

Sample Size	0.6 µL
Test Time	5 seconds
Memory Capacity	1000 test results
Display	LCD
Measurement Range	10 to 600 mg/dL
Connectivity	Infrared
Sample Type	Capillary whole blood
Operating Temperature	16 to 32°C (61 to 90°F)
Relative Humidity	10 to 90% non-condensing