Accu-Chek Inform II

Appendix • A
181
08424705001 (01) 2017-04 USA • Accu-Chek Inform II Operator’s Manual Version 6
A Appendix
A.1 Table of configuration options
This section provides an overview of all the settings
available.
The two rightmost columns describe the accessibility of a
configuration parameter on the device (Setup Menu) and
via the data management system (DMS).
“Y” (Yes) means, that this parameter is available, “N” (No)
means, that this parameter is not available using the
respective configuration method.
Configuration options
DEVICE: If the meter is configured by a system admin-
istrator using a data management system, the configu-
ration options on the meter may be disabled to avoid
conflicts in the settings. This option is indicated by the
use of parentheses e.g., (Y).
DMS: Configuration options may vary depending on
available DMS settings.
Subject/Attribute Range Default Device DMS
Timer
Power-off timeout (meter powers off
automatically if no activity)*
30 – 3,600 s 300 N Y
* Not applicable in measurement mode (see “Automatic power-off” on page 22).
Beeper
Beeper volume 0: low
1: medium
2: high
2YY