Accu-Chek Inform II User Manual

Maintenance and Care • 10
149
08424705001 (01) 2017-04 USA • Accu-Chek Inform II Operator’s Manual Version 6
Acceptable cleaning/
disinfecting agents
■ To purchase approved disinfecting products,
please refer to your facility’s guidelines, which may
include instructions on direct purchase from the
agent manufacturer or through an approved
distributor. For additional information on product
availability for purchase, refer to manufacturer’s
website: http://www.cloroxprofessional.com
for Clorox
®
Germicidal Wipes or
http://www.pdipdi.com/ for Super Sani-Cloth
®
Germicidal Disposable Wipes.
■ Dispose of acceptable cleaning and disinfection
solutions per facility guidelines.
Acceptable active ingredients and products for cleaning
and disinfecting are:
– Clorox
®
Germicidal Wipes (Environmental
Protection Agency (EPA) reg. no. 67619-12) Pre-
moistened disinfecting cloths (active ingredient 1%
(or less) solution of sodium hypochlorite in water)
– Super Sani-Cloth
®
Germicidal Disposable Wipes
(EPA reg. no. 9480-4) Pre-moistened disinfecting
cloths (active ingredient 0.5% quaternary
ammonium chlorides and up to 60% isopropanol)
■ Cleaners and disinfectants were validated sepa-
rately and only one cleaning/disinfecting solution
should be used on the device as the effect of using
more than one cleaner/disinfectant interchangea-
bly has not been evaluated.
NOTE: Always use Clorox Germicidal Wipes (EPA reg. no.
67619-12) or Super Sani-Cloth Germicidal Disposable
Wipes (EPA reg. no. 9480-4) to clean and disinfect the
meter. Do not use any other cleaning or disinfecting solu-
tion. Using solutions other than Clorox Germicidal Wipes
(EPA reg. no. 67619-12) or Super Sani-Cloth Germicidal
Disposable Wipes (EPA reg. no. 9480-4) could result in
damage to the system components.
NOTE: Roche has tested the approved cleaning and dis-
infecting product for a total of 12,045 cycles, which is
equal to cleaning and disinfecting after each patient use
simulating 3 years of device use.

Accu-Chek Inform II Specifications

General

Sample Size	0.6 µL
Test Time	5 seconds
Memory Capacity	1000 test results
Display	LCD
Measurement Range	10 to 600 mg/dL
Connectivity	Infrared
Sample Type	Capillary whole blood
Operating Temperature	16 to 32°C (61 to 90°F)
Relative Humidity	10 to 90% non-condensing