Accu-Chek Inform II User Manual

Patient Glucose Testing • 3
61
08424705001 (01) 2017-04 USA • Accu-Chek Inform II Operator’s Manual Version 6
Applying a blood sample Once the meter has checked the test strip, the hourglass
icon disappears and you are prompted to apply a blood
sample.
1 Wait until the flashing drop appears in the display
before applying the blood. The meter beeps.
2 Apply the drop of blood to the front edge (yellow
dosing area) of the test strip. Blood is pulled into
the test strip by capillary action.
Do not apply the blood to the top of the strip. Blood
on top of the test strip is not available for testing
because it will not be pulled into the strip.
Once a sufficient blood sample has been detected, the
meter beeps and the measurement begins.
Patient Test
Patient 123456789
Strip L
ot 545794
12:48 pm
DOB: 12/05/70
03/17/17
When applying the sample, position the meter so that
the test strip port is always higher or on the same level
as the blood drop. This prevents any excess blood from
flowing down the strip and entering the meter.

Accu-Chek Inform II Specifications

General

Sample Size	0.6 µL
Test Time	5 seconds
Memory Capacity	1000 test results
Display	LCD
Measurement Range	10 to 600 mg/dL
Connectivity	Infrared
Sample Type	Capillary whole blood
Operating Temperature	16 to 32°C (61 to 90°F)
Relative Humidity	10 to 90% non-condensing