Accu-Chek Inform II User Manual

Powering Up and Entering an Operator ID • 2
41
08424705001 (01) 2017-04 USA • Accu-Chek Inform II Operator’s Manual Version 6
2 Powering Up and Entering an Operator ID
2.1 Powering up the meter
1 Press and release the On/Off button . The meter
is now on.
2 The Power Up screen appears.
3 Check in the Power Up screen whether the date
(lower left) and time (upper right) are displayed
correctly. If necessary, refer to the instructions for
updating these settings in Chapter 9.
■ If during self-check an error is detected, the appro-
priate error message appears on screen.
■ If the QC Lockout feature is enabled and glucose
control is required, a corresponding message is
displayed.
■ The battery icon shows the current battery level.
A completely filled icon indicates a fully
charged battery, and a partial charge is displayed
as a partially filled battery icon . If the battery
is nearly empty, the battery icon turns red .
Contrast
Power Up 12:48 pm
03/17/17
Performing self-checks...

Accu-Chek Inform II Specifications

General

Sample Size	0.6 µL
Test Time	5 seconds
Memory Capacity	1000 test results
Display	LCD
Measurement Range	10 to 600 mg/dL
Connectivity	Infrared
Sample Type	Capillary whole blood
Operating Temperature	16 to 32°C (61 to 90°F)
Relative Humidity	10 to 90% non-condensing