Accu-Chek Inform II User Manual

48
08424705001 (01) 2017-04 USA • Accu-Chek Inform II Operator’s Manual Version 6
Preparing to test
The following requirements must be met before you can
perform a test:
■ The Accu-Chek Inform II test strips are available.
■ At least one code file for test strips must be stored
in the meter and match the lot number of the test
strips used (see Chapter 6).
■ An operator ID must be entered (with password, if
required), if the meter is configured for login.
■ Glucose control tests specified in the system con-
figuration must be run and completed successfully
before running patient tests. Information whether
glucose control tests are necessary is displayed in
the Power Up screen.
■ If configured, the meter may require downloading
stored data to the data management system within
defined time intervals. If such a download (either
via WLAN or by docking the meter in a base unit)
does not happen within the specified time, the
meter is locked (Download Lockout) and cannot be
used for testing.
For more detailed information regarding the Accu-Chek
Inform II test strip, refer to the package insert for
instructions for use, performance characteristics, and
limitations of the system.
Contrast
Power Up
QC Due: Immediately
12:48 pm
03/17/17

Accu-Chek Inform II Specifications

General

Sample Size	0.6 µL
Test Time	5 seconds
Memory Capacity	1000 test results
Display	LCD
Measurement Range	10 to 600 mg/dL
Connectivity	Infrared
Sample Type	Capillary whole blood
Operating Temperature	16 to 32°C (61 to 90°F)
Relative Humidity	10 to 90% non-condensing