Accu-Chek Inform II User Manual

Patient Glucose Testing • 3
57
08424705001 (01) 2017-04 USA • Accu-Chek Inform II Operator’s Manual Version 6
If the meter is configured to use the “Isolation Room
Workflow” (see Appendix A.1) the strip lot will be con-
firmed before a patient ID is entered or selected.
For additional information about storing lot numbers for
test strips, see page 87.
Patient Test
Use Strip Lot
12:48 pm
123456?
03/17/17
Strip Lots
344789
545794
545777
344654
12:48 pm
03/17/17
123
456
789
A-O0
Patient ID
12:48 pm
03/17/17
The meter can be configured so that manual confirma-
tion is not necessary. In this setup, only the lot number
is displayed. Additional options are not available.
The meter can be configured so that lot numbers are
entered via barcode scanner only (see note below).
Note: Barcodes on control solutions may not be availa-
ble in all countries. In this case either
■ manually enter the lot number each time
(recommended),
■ pick a previously entered lot number from the list, or
■ configure the meter to only display the lot number
(without confirmation by the operator).

Accu-Chek Inform II Specifications

General

Sample Size	0.6 µL
Test Time	5 seconds
Memory Capacity	1000 test results
Display	LCD
Measurement Range	10 to 600 mg/dL
Connectivity	Infrared
Sample Type	Capillary whole blood
Operating Temperature	16 to 32°C (61 to 90°F)
Relative Humidity	10 to 90% non-condensing