230 Firmware Version 6.0
2. Product Selection
Select product from the drop-down list or press
to create a new one.
3. Configure Product Mix
When using a product template, the mix contents
and amounts are defined at the map screen by:
-a.activating or de-activating products
-b.changing rate or total amount of a product
-c.changing total amount of the product or overall rate of
product application
These values can be changed on the Configure
Product Mix screen which is available in the event
setup wizard or by pressing a product line on the
home screen.
A product can not be active with a rate of zero.
If a configuration is loaded with undetected modules,
the Product Selection screen may show some
grayed out (unavailable) options. The example to the
left shows that the Direct Command module is active
but Direct Injection, Crop Sensor, and Boom Control
modules are grayed out and not functional.
When all product mixes have been configured press .
Product Selection
DC COM10K
DL1
Crop Sensor
Boom Control
Active
Active
Active
Select Product
Active
28% UAN
To Next Page
Loading...
Need help?
General
