315 Ag Leader PN 4002083 Rev. N
A
PPLICATION
S
TRIP
T
ILL
APPLICATION
STRIP TILL
DirectCommand for Strip-Till applicators monitors bin level and fan speed sensors, maintains an
accurate application rate and supports multiple product prescription rate control for up to three granular
products. The Strip Till module supports PWM and Motorized Servo valves as well as Linear Actuator
Product Control. System can be configured for Strip Till fertilizer application or Air Seeder (Planting)
control. To create an Air Seeder (Planting) configuration continue to
“Create Air Seeder Configuration” on
page 317.
CREATE STRIP TILL FERTILIZER CONFIGURATION
Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > Add
(+) button > Application button
A wizard will guide you through the process of selecting or creating a vehicle, implement and controller.
1. Select Vehicle
Use drop-down menu to choose a vehicle, or press to enter a new vehicle. Press to
continue.
Note: It is recommended that Vehicle Offset Information be entered before continuing with the configuration
process.
2. Select Implement
Select an implement from the drop-down list menu, or press to create a new implement. Press
to continue.
3. Select Implement Attachment Type
Use the drop-down list to select an implement attachment method. Press to continue.
4. Enter Hitch to Implement Axle Distance
Press to enter the hitch to implement axle distance. Press to accept.
5. Add Strip Till Functionality to the Implement
Press then to add Strip Till functionality to the implement.
6. Select Controller
Use the drop-down menu to select controller or press to add a controller. Press to
continue.
To Next Page
Loading...
Need help?
General
