264 Firmware Version 6.0
STATUS SCREEN
The status screen provides the user with
readout of the connected controller’s
target rate, actual rate, section status,
and connection status.
Note: The target rate is not available for edit from the VT screen. Target rate can only be adjusted
from the Run Screen.
Serial Connection Status – Indicates if the ISOBUS Serial Application Rate
module is communicating with the connected controller.
Target Rate Status – Indicates the target rate sent to the connected controller.
Actual Rate Status – Indicates the actual rate received from the connected
controller.
Boom Section Status – Indicates the on/off status of the
boom sections sent to the connected controller.
To Next Page
Loading...
Need help?
General
