266 Firmware Version 6.0
Warning Enabled – With this setting enabled, the user
will get a “Rate Not Responding” alarm when the
actual rate does not fall within the threshold and
timeout settings. The user will not receive an alarm if
this setting is disabled.
Rate Not Responding Threshold – This setting
defines the percent value the actual rate can be off
from the target rate and not trigger the “Rate Not
Responding Alarm” alarm.
Rate Not Responding Timeout – This setting defines
the amount of time the actual rate can fall outside the
Rate Not Responding Threshold without triggering the
“Rate Not Responding Alarm” alarm.
DIAGNOSTICS
Press Diagnostics button.
Module Diagnostics – Contains module
diagnostic information to assist in troubleshooting.
Alarms – Contains any active alarms from the
module.
To Next Page
Loading...
Need help?
General
