Agilent 8453 UV-visible Spectroscopy System Operator’s Manual 37
Installation and Start Up 2
Installation Summary for Your Agilent 8453 General Purpose UV-visible System
PC
✔ Make sure that all of your PC components are connected to line power.
✔ Make sure that your general purpose software for UV-visible spectroscopy is
installed.
✔ A printer must be configured on your PC.
• Adjust paper size (for example, Letter, A4)
• Set Orientation to Portrait
✔ The TCP/IP protocol must be installed and configured on your PC.
✔ Your spectrophotometer must be configured with its IP address.
✔ If you connected your spectrophotometer directly to your PC be sure that
the Agilent Bootp Service is installed and configured. If you connect to your
spectrophotometer using a LAN make sure that your network administrator
assigns the IP address to your spectrophotometer.
To Next Page
Loading...
Need help?
General
