Understanding Your Agilent ChemStation 121
Quantification
5
ESTD Calculation
Figure 28 Response Factor
The multiplier and dilution factor are read either from the Calibration Settings
or from the Sample Information dialog box.
If the ESTD% report is selected and sample amount is not zero, the relative
amount (%) of a component x is calculated as shown below:
where:
Absolute amount of x is calculated as shown above in the ESTD calculation;
Sample amount is obtained from the Sample Information box, or from the
Calibration Settings dialog box for single runs. If sample amount is zero, the
ESTD is calculated.
6bdjci
GZhedchZ
6bdjcim
GZhedchZm
G;m
To Next Page
Loading...
Need help?
General
