Understanding Your Agilent ChemStation 229
Using the ChemStation Reports
10
Sequence Summary Reporting
Sequence Output
In the Sequence Output dialog box you can define where the sequence summary
report should be printed.
Select Report to file and enter a file name to print the report to the specified
file. The default setting is that data are saved to the file GLPrprt.txt. In GC
systems with dual injection the data are saved in GLPrptF.txt and GLPrptB.txt
for the front injector and back injector respectively.
Select Report to PDF to save the report as a PDF document. The report is saved
in the sequence folder with the name CLPrprt.PDF
Select Report to HTM to print the report in HTML format. The report is saved
into an HTM directory in the data directory specified in the Sequence
Parameters. The HTM report consists of an index file (index.htm) and at least
two other files, a contents file (contents.htm) and a GIF (Graphics Interchange
Format) file for each page of the report (e.g. page1.gif). To view the html
report, open the index file using your browser.
Select Report to printer to print the report on the system’s printer. Print
individual reports for each run also activates printing of sample reports after
each analysis. These reports are printed in addition to the reports specified
for the sequence summary report which are produced at the end of the entire
sequence. You can specify a new destination for these reports in the Sequence
Output dialog or use the destination specified in the individual methods.
To Next Page
Loading...
