xxii N19121A/1912A P-Series Power Meters User’s Guide
Figure 4-107 Trace display with gate control menu 142
Figure 4-108 Trace display with trigger delay menu 143
Figure 4-109 Trace display with trace control menu 145
Figure 4-110 Trace display in full screen 146
Figure 4-111 E-Series E9320 power sensor dafault channel setup 147
Figure 4-112 Channel offset display 148
Figure 5-113 E9300 E-Series auto-averaging settings 153
Figure 5-114 E9300 E-Series sensor default channel setup 154
Figure 5-115 Frequency pop-up 156
Figure 5-116 Spread spectrum signal 157
Figure 5-117 Wideband CDMA error of E-Series E9300 power sensor versus corrected
CW sensor. 158
Figure 5-118 CDMA (IS-95A): 9Ch Fwd 158
Figure 5-119 Calibration factors versus frequency 159
Figure 6-120 E-Series CW sensor auto-averaging settings 169
Figure 6-121 E-Series E4410 sensor default channel setup 170
Figure 6-122 Frequency pop-up 172
Figure 7-123 8480 Series auto-averaging settings 175
Figure 7-124 8480 Series sensor default channel setup 176
Figure 7-125 Reference Calibration Factor pop-up window 181
Figure 7-126 Calibration factor pop-up window 182
Figure 7-127 Calibration factor display 182
Figure 7-128 Sensor table selected 185
Figure 7-129 Frequency dependent offset indicator 185
Figure 7-130 Frequency/calibration table display 186
Figure 7-131 “Sensor Tbls” screen 188
Figure 7-132 “Edit Cal” display 189
Figure 7-133 Edit table title pop-up 189
Figure 8-134 Auto-averaging settings 198
Figure 8-135 N8480 Series sensor (excluding Option CFT) default channel setup 199
Figure 8-137 Frequency pop-up 202
Figure 8-138 Reference calibration factor pop-up window 204
Figure 8-139 Calibration factor pop-up window 205
Figure 8-140 Calibration factor displayed 206
Figure 8-141 Sensor table selected 209
To Next Page
Loading...
