Introduction 1
N1911A/1912A P-Series Power Meters User’s Guide 23
An example of the Web browser is shown in “N1912A P- Series power
meter Web browser (Welcome Page)” on page 23.
Figure 1-9 N1912A P-Series power meter Web browser (Welcome Page)
Instrument on the network can be physically identified through the Status
message on Remote Interfaces screen by clicking Toggle ID within the
Web browser. This changes the status of the Instrument ID to ON or OFF.
Before the instrument identification starts, press
,
to view the Status message.
When Instrument ID is toggled to ON, this causes the Status message
“LAN identify start” in Remote Interface screen on the front panel to
blink 3 times. When the Toggle ID is selected again, the default Status
message “Running” is returned. See Figure 1- 10 and Figure 1- 11.
To Next Page
Loading...
