Using E9320 E-Series Power Sensors 4
N1911A/1912A P-Series Power Meters User’s Guide 145
Figure 4-109Trace display with trace control menu
The fields on the lower left of the screen are the X and Y trace setup
fields. Using the or keys you can highlight the item and change its
value. (See Figure 4- 109)
The table on the lower right of the screen shows the 8 automatic time
measurements performed on the first complete captured pulse after the
trigger. The 8 measurements are rise time, fall time, time to positive
occurrence, time to negative occurrence, pulse width, pulse period (pulse
repetitive interval), pulse repetitive frequency and duty cycle.
The current settings of the X and Y scale are displayed on the reporting
line above both tables.
Trace Setting
Rising Edge
Gate 2 Active
Duty Cycle
Pulse Repetitive Frequency
Pulse Period
Pulse Width
Falling Edge
If you want to view the trace in linear mode, the Trace Setup is the only location where you
can change the Y-scale units from
dBm to Watts; otherwise the default unit is in logarithmic.
To Next Page
Loading...
