Introduction 1
N1911A/1912A P-Series Power Meters User’s Guide 3
Power Meter and Sensor Capability
Your P- Series power meter is compatible with Agilent P- Series, E- Series
E9320, E- Series E9300, E- Series E4410, 8480 Series and the N8480 Series
power sensors. However, not all sensor and meter combinations have the
same features or capabilities. The main differences are as below:
1
Not applicable for N8480 Series power sensors with Option CFT
Specifications
The specifications for the power meter are listed in Chapter 11,
“Specifications and Characteristics,” starting on page 253.
Features P-Series
N1920
E-Series
E9320
E-Series
E9300
E-Series
E4410
8480
Series
N8480
Series
Average power of CW signal
•••• ••
Average power of modulated signal
••• ••
Peak power
••
Cal factors stored on EEPROM
••••
•
1
>200 readings/sec
••••
Peak/burst average power
••
Time gated measurements
••
Rising edge trigger
••
Falling edge trigger
••
• The E-Series, 8480 Series and N8480 Series power sensors require N1917A/B/C cables
when connected to the P-Series power meters.
• The N8480 Series power sensors used in this user’s guide is refering to all sensors from
the N8480 Series unless otherwise stated.
To Next Page
Loading...
Need help?
General
