3 Using P-Series Power Sensor
128 N1911A/1912A P-Series Power Meters User’s Guide
•
Video B/W: “Setting the Video Bandwidth” on page 54
Setting Offsets
Press . The Offsets Setup screen is displayed.
Figure 3-100Channel offset display
Use the , , , and keys to highlight any parameters you want to
change. Press to configure the required settings. For further detail
on setting these, refer to the appropriate section.
• Offset
: “Setting Channel Offsets” on page 39
• FDO Table
: “Setting Frequency Dependent Offsets” on page 42
Trigger Setup
Press . The Trigger menu is displayed.
The trigger status is displayed below the label in the Trigger menu.
Press the softkey and add more accuracy to the remaining trigger
parameters, for example, hold- off and hysteresis, to help you achieve a
stable and reliable trigger. Hence, this ensures that the gates you have set
up are capturing the required signal information. See Chapter 2, “Setting
To Next Page
Loading...
Need help?
General
