INTRODUCTION
S2000 Operator’s Manual - Version 1.30 Page 3
• Data storage A variety of storage devices may be used to store data
including floppy disk, hard disk, Syquest™ removable
cartridges and Magneto Optical (MO) disks. Hard disk data may
be backed up to a normal DAT tape using the optional digital
i/o.
• Flash ROM You may install up to 16Mbytes of FLASH ROM over and
above the 32Mbytes of ordinary RAM giving you a total of
48Mbytes of memory. FLASH ROM allows you to keep your
favourite sounds in memory even when the sampler is
switched.
• OPERATING MODES
SINGLE For playing single programs.
MULTI For playing up to 16 programs together for multi-timbral
sequencing, layering and key splits.
SAMPLE For making recordings.
EFFECTS For selecting effects.
EDIT For editing programs, samples and effects.
GLOBAL For setting parameters that affect the module.
SAVE For saving programs, samples, multis, effects and operating
systems, etc., to floppy or hard disk and CD-ROM.
LOAD For loading programs, samples, multis, effects, operating
systems, etc., from floppy or hard disk and CD-ROM.
• EDITING FEATURES
EDIT SAMPLE Trim, Loop (with FIND and CROSSFADE functions), Reverse,
Gain normalisation, Timestretch, Re-sample.
EDIT PROGRAM Resonant lowpass filters, ADSR envelope generator (with
templates), multi-stage envelope generator (with templates),
2 x multi-wave LFOs, sample layering, 4-way velocity
crossfade and switching, keygroup crossfade, portamento
(rate and time modes), monophonic legato triggering, mute
group function, panning and autopanning, held pitchbend
mode, separate pitchbend up/down ranges, output selection.
(With 2nd filter bank installed, a further set of multi-mode filters
and a third multi-stage envelope generator are added).
MULTI Part select, program select, MIDI channel, level, pan,
transpose, fine tune, output routing, FX routing, FX send, low
key range, high key range, note priority.
To Next Page
Loading...
Need help?
General
