Akai s2000 User Manual

EFFECTS
Page 166 S2000 Operator’s Manual - Version 1.30
CHAINING EFFECTS
Not only is it possible to have the multi-effects with distortion/EQ>mod/delay>reverb on FX1
and FX2 but you may also feed the outputs of these two channels to the ‘spare’ reverb
channels RV3 and RV4. This allows you to add reverb to reverb. At first this may seem a bit
pointless but one use that immediately springs to mind is adding a hint of ‘acoustic’ reverb to a
gated or reverse reverb effect. This is done in the REVERB 3 SOURCE page.:
You may select RV3’s input. You may select from the following options:
RV3 RV3 will be fed with whatever is routed to RV3 in the SINGLE
or MULTI modes or in EDIT SINGLE, keygroup FX page.
FX1 This will route anything routed to the FX1 buss to RV3.
PATH CONTROL
MOD/ECHO
REVERB
PATH
PATH
DIST/EQ
L/R outs
L/R outs
RV3 REVERB
L/R outs
FX1
This allows you to send one sound (internal or external to two reverbs.
FX1 DIST/EQ The output of the distortion/EQ section of FX1 will be fed to RV3:
PATH CONTROL
MOD/ECHO
REVERB
PATH
PATH
DIST/EQ
L/R outs
L/R outs
RV3 REVERB
L/R outs

Akai s2000 Specifications

General

Type	Sampler
Polyphony	32 voices
Sampling Frequency	44.1kHz
Filters	Digital low-pass filter
MIDI	In, Out, Thru
Bit Depth	16-bit
Memory	2 MB, expandable to 32 MB
Outputs	8 individual outputs, stereo master output
LFO	1 LFO
Display	LCD
Storage	3.5" Floppy Disk
Inputs	Stereo input