SAVE
S2000 Operator’s Manual - Version 1.30 Page 39
NOTES ON SAVING DATA
Saving the entire memory contents is a quick and convenient way to save data. However, be
aware of a few things:
1 You should have enough free disk space to save everything. If you are saving to a
floppy, once the floppy is full, you will be prompted:
Insert a new floppy disk and press F2 - CONTINUE. If further floppy disks are required,
you will continue to see this prompt until the save is complete. If you wish to abort the
save process when you receive this message, press F1.
2 If you are saving to hard disk and the disk becomes full, you will see this prompt:
There’s not much you can do about this other than clear some space from other
volumes.
3 Be very careful not to accidentally overwrite a floppy disk or hard disk volume when you
save. It’s very easy to work quickly on the S2000 and to press SAVE, GO, WIPE
without thinking but, when saving data, it’s worth being careful. If you have any doubts
at all about the contents of a floppy disk or hard disk volume you are about to save to,
press LOAD to check the contents first.
To Next Page
Loading...
Need help?
General
