Akai s2000

S2000 Operator’s Manual - Version 1.30 i
WARNING
The S2000 is designed to be used in a standard household environment.
Power requirements for electrical equipment vary from area to area. Please ensure that your
S2000 meets the power requirements in your area. If in doubt, consult a qualified electrician or Akai
Professional dealer.
120 VAC @ 60 Hz for USA and Canada
220~230/240 VAC @ 50 Hz for Europe
240 VAC @ 50 Hz for Australia
PROTECTING YOURSELF AND THE S2000
• Never touch the AC plug with wet hands.
• Always disconnect the S2000 from the power supply by pulling on the plug, not the cord.
• Allow only an Akai Professional dealer or qualified professional engineer to repair or reassemble
the S2000. Apart from voiding the warranty, unauthorized engineers might touch live internal
parts and receive a serious electrical shock.
• Do not put, or allow anyone to put any object, especially metal objects, into the S2000.
• Use only a household AC power supply. Never use a DC power supply.
• If water or any other liquid is spilled into or onto the S2000, disconnect the power, and call your
dealer.
• Make sure that the unit is well-ventilated, and away from direct sunlight.
• To avoid damage to internal circuitry, as well as the external finish, keep the S2000 away from
sources of direct heat (stoves, radiators, etc.).
• Avoid using aerosol insecticides, etc. near the S2000. They may damage the surface, and may
ignite.
• Do not use denaturated alcohol, thinner or similar chemicals to clean the S2000. They will
damage the finish.
• Modification of this equipment is dangerous, and can result in the functions of the S2000 being
impaired. Never attempt to modify the equipment in any way.
• Make sure that the S2000 is always well-supported when in use (either in a specially-designed
equipment rack, or a firm level surface).
• When installing the S2000 in a 19" rack system, always allow 1U of ventilated free space above
it to allow for cooling. Make sure that the back of the rack is unobstructed to allow a clear airflow.
• In order to assure optimum performance of your S2000, select the setup location carefully, and
make sure the equipment is used properly. Avoid setting up the S2000 in the following locations:
1. In a humid or dusty environment
2. In a room with poor ventilation
3. On a surface which is not horizontal
4. Inside a vehicle such as a car, where it will be subject to vibration
5. In an extremely hot or cold environment
WARNING