P12s Moderate block error rate
...................................................................................................................................................................................................................................
Alarm identifier
P12ScDEG
Information P12s signal degrade protected. The block error rate of an incoming P12s signal
exceeds an error threshold in a protected configuration (PDH -> SDH).
Alarm category Transmission
ASAP
Alarm severity
(default setting)
Deferred
Reporting state
(default setting)
Reported
Local indications –
Cause Fault(s) in upstream external cabling or equipment.
Actions Check upstream external cabling and equipment.
Note(s) The fault detection monitors on ts0
Alarm messages
...................................................................................................................................................................................................................................
1-92
Alcatel-Lucent - Proprietary
See notice on first page
365-312-803R7.2
Issue 4, May 2007
To Next Page
Loading...
