34 Mbit/s extension board failure
...................................................................................................................................................................................................................................
Alarm identifier
E31XcUPF
Information The 34 Mbit/s extension board (X2E3-V2) is defective.
ASAP equipment
Alarm severity
(default setting)
Prompt
Reporting state
(default setting)
Reported
Alarm category Equipment
Local indications The red fault LED on the unit is lit.
Cause A hardware failure of the 34 Mbit/s extension is detected.
Actions Remove the 34 Mbit/s extension board and replace it with another one.
Note(s) As there is no equipment protection of the 34 Mbit/s extension board,
E31XcEQF and E31XcUPF are always reported simultaneously as a reminder
that a hardware failure is service affecting.
Alarm messages
...................................................................................................................................................................................................................................
1-36
Alcatel-Lucent - Proprietary
See notice on first page
365-312-803R7.2
Issue 4, May 2007
To Next Page
Loading...
