Wrong STM-1 interface extension board present
...................................................................................................................................................................................................................................
Alarm identifier
STM1XcWUP
Information An STM-1 interface extension board is provisioned, but an extension board of
a different type is present, or the present extension board cannot be identified.
A proper downloading of the software will not be possible.
Alarm category Equipment
ASAP equipment
Alarm severity
(default setting)
Prompt
Reporting state
(default setting)
Reported
Local indications The red “Fault” LED is lit.
Cause Wrong extension board inserted, or the inserted extension board is defective.
Actions Insert an STM-1 interface extension board, or change the provisioning.
Alarm messages
...................................................................................................................................................................................................................................
1-318
Alcatel-Lucent - Proprietary
See notice on first page
365-312-803R7.2
Issue 4, May 2007
To Next Page
Loading...
