X21 interface loss of input signal
...................................................................................................................................................................................................................................
Alarm identifier
X21cLOS
Information There is no input signal at the corresponding X.21 port.
Alarm category Transmission
ASAP ethPS
Alarm severity
(default setting)
Prompt
Reporting state
(default setting)
Reported
Local indications The red “Fault” LED is lit.
Cause Possible causes may be a cable break or wrong physical connections for
example.
Actions Check the cabling.
Alarm messages
...................................................................................................................................................................................................................................
365-312-803R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
1-323
To Next Page
Loading...
