Q-LAN termination loopback failed
...................................................................................................................................................................................................................................
Alarm identifier LANcTRM
Information Q-LAN is not terminated.
Alarm category Processing error
ASAP dcn
Alarm severity
(default setting)
Information
Reporting state
(default setting)
Not Reported
Local indications The red fault LED is flashing.
Cause Q-LAN terminator loopback is interrupted.
Actions
• Check cabling.
• Check interface connections.
• Check Q-LAN termination stubs.
• Check the ITM-SC in the indicated network element.
Note(s) This alarm only reports a loopback failure in the Q-LAN, therefore it should be
sufficient to check for hitches in the Q-LAN cable or check the reporting
SC-unit (which contains the Q-LAN device).
In general this alarm will only be reported on the ITM-CIT since the ITM-SC
will have lost association with the network element.
Alarm messages
...................................................................................................................................................................................................................................
365-312-803R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
1-117
To Next Page
Loading...
