EasyManua.ls Logo

Alcatel-Lucent 1643 AMS - LAN unit failure

Alcatel-Lucent 1643 AMS
386 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LAN unit failure
...................................................................................................................................................................................................................................
Alarm identifier
IPcUPF
Information The TransLAN
®
option board (X8PL or X4IP-V2) is defective.
Alarm category Equipment
ASAP equipment
Alarm severity
(default setting)
Prompt
Reporting state
(default setting)
Reported
Local indications
The red fault LED on the unit is lit.
The green LED associated to the respective port is lit on the TransLAN
®
option board. The green LED indicates the link status of the port.
The yellow LED associated to the respective port is lit on the TransLAN
®
option board. The yellow LED indicates (RX/TX) activity on the port.
Cause A hardware failure of the TransLAN
®
option board has been detected.
The TransLAN
®
option board is starting up.
Actions If the alarm is still present after 1 minute, then replace the TransLAN
®
option
board.
Note(s) As there is no equipment protection of the TransLAN
®
option board, IPcEQF,
and IPcUPF are always reported simultaneously as a reminder that a hardware
failure is service affecting.
Alarm messages
...................................................................................................................................................................................................................................
1-72
Alcatel-Lucent - Proprietary
See notice on first page
365-312-803R7.2
Issue 4, May 2007

Table of Contents

Other manuals for Alcatel-Lucent 1643 AMS