Each alarm can be assigned one of the following reporting states:
Alarm severity Meaning
Reported The alarm - when raised - will be reported towards the
management systems (ITM-SC and ITM-CIT), and displayed
on the graphical user interfaces.
Not Reported The alarm - when raised - will not be reported.
Please note that changing the alarm reporting state does not affect the display of
currently present and history alarms. Especially the display of already present alarms
cannot be removed if their reporting state is changed from “Reported” to “Not
Reported”.
Local indications
Local indications are indications directly at the network element, typically via
light-emitting diodes (LEDs), especially via the red fault LED on the unit.
Please note that the local indications via the red fault LED are controlled by defects,
not alarms.
Contents
Operation modes 1-14
1.5 Mb extension board failure 1-17
1.5 Mbit/s ext board failure 1-18
1.5 Mbit/s extension board removed 1-19
1.5 Mbit/s Loss of input signal 1-20
1.5 Mbit/s Not expected input signal 1-21
1.5 Mbit/s output timing mode change 1-22
2 Mbit/s Alarm indication signal received 1-23
2 Mbit/s Excessive FAW bit error rate 1-24
2 Mbit/s Excessive FAW bit error rate egress 1-25
2 Mbit/s extension board failure 1-26
2 Mbit/s extension board failure - protected 1-27
2 Mbit/s extension board removed 1-28
2 Mbit/s Frame slip/skip count threshold crossing 15-min 1-29
2 Mbit/s Frame slip/skip count threshold crossing 24-hrs 1-30
2 Mbit/s Loss of frame alignment 1-31
2 Mbit/s Loss of input signal 1-32
Alarm messages
Overview
...................................................................................................................................................................................................................................
1-4
Alcatel-Lucent - Proprietary
See notice on first page
365-312-803R7.2
Issue 4, May 2007
To Next Page
Loading...
