Common Procedures ML248xA / ML249xA
13000-00162 5-59
September 2005
Setting the Duty Cycle in CW Mode
This menu is used to set up and apply duty cycle correction to the currently active channel
in CW mode.
1. Ensure that the currently active channel is set to CW mode.
2. Press the Channel hard key followed by the Duty Cycle soft key.
3. Press the Set Duty Cycle soft key to display the [Set Duty Cycle] dialog. Press [Sel]
and enter the required duty cycle correction value from the keypad in the normal
manner.
4. Press [Exit] and then press the Duty Cycle soft key to enable the setting. When the
duty cycle setting is enabled, the LED on the soft key is lit green.
To Next Page
Loading...
Need help?
General
