Anritsu ML2480B Series User Manual

13000-00162 D-1
September 2005
Appendix D. ML2400A Reference Table
Note: The information in this chapter may be of benefit to users already familiar with
existing Anritsu power meters.
In addition to the obvious differences between the ML248xA / ML249xA and the power
meters in the ML2400A series, there are also many similarities in the basic grouping of
commands and operation concepts. Users familiar with the ML2400A series power
meters should quickly be able to adapt to the improvements made on the ML248xA /
ML249xA. To make this process easier, this chapter provides a table summarizing some
of the key differences in terms of the location of the commands. This information will not
be of benefit to users who are new to Anritsu power meters.
The table below is split into three columns, the left column detailing the procedure or
command in question, and the center and right side columns giving the required hard and
soft key combinations for both the ML248xA / ML249xA and ML2400A.
Command /
Procedure
ML2400A series ML248xA / ML249xA
Averaging
Sensor / Averaging Channel / Averaging
Triggering
Trigger Channel / Trigger
Markers
(cursor)
System / Control Channel / Markers
Preset
System / Setup / More / Preset Preset
Measurement
display
System / Setup / Mode Channel / Setup / “Meas display”
Change
channel
Channel / Set Up / Channel Ch1/Ch2
Capture time,
delay, and
data hold
System / Profile Channel / Trigger
Scaling
System / Control / More / Scale Channel / More / Scaling
Data hold
System / Profile / Data hold Channel / More / Profile Display

Anritsu ML2480B Series Specifications

General

Brand	Anritsu
Model	ML2480B Series
Category	Measuring Instruments
Language	English