Anritsu MS9740B - Page 130

Chapter 4 Changing Measurement Conditions
4-12
To display peak point in ascending order or dip point in descending order:
Press
f4 Next
.
At peak point display, the trace marker moves to the next peak level. At
dip point display, the trace marker moves to the next dip level.
To display peak point in descending order or dip point in ascending order:
Press
f5 Last
At peak point display, the trace marker moves to the previous peak level.
At dip point display, the trace marker moves to the previous dip level.
To display peaks and dips to left of current position:
Press
f6 Left
.
The trace marker moves to the next peak or dip on the left.
To display peaks and dips to right of current position:
Press
f7 Right
.
The trace marker moves to the next peak or dip on the right.
To release peak/dip display:
Press
f3 Off.
To set threshold that detects peak and dip points.
1. Press
f8 More 1/2
.
2. Press
f1 Search Threshold Auto Manual
, select
Manual.
3. Set
f2 Search Threshold
.
Peak and dip points are detected with the specified threshold.
Notes:
● Peak and dip points are detected automatically, regardless of
Search Threshold setting values.
● Search Threshold setting values are used for the threshold to
detect next higher peak point or next lower dip point.
To display Peak to Peak of peak/dip points.
1. Press
f8 More 1/2
.
2. Set
f4 Peak to Peak Calculation
to On.
Peak to Peak level is displayed on the screen, and the color of
peak/dip points change.