Anritsu MS9740B - Connecting Remote Control Devices

2.5 Connecting Remote Control Devices
2-11
2
Before Use
2.5 Connecting Remote Control Devices
Ethernet
Connect the Ethernet cable to the rear-panel left Ethernet connector.
Do not use the right Ethernet connector.
Use a category-5 or better crossover cable.
GPIB
GPIB can be used when the MS9740B-001/101 is installed.
Connect the cable to the rear-panel GPIB connector.
Note:
The MS9740B cannot print directly to a printer with a GPIB
interface.