Anritsu MS9740B - Changing Measurement Mode

4.7 Changing Measurement Mode
4-27
4
Changing Measurement Conditions
4.7 Changing Measurement Mode
The spectrum measurement modes are listed below.
● High dynamic range mode (High D.Range)
● Sweep start using external trigger (Ext Trigger)
● Sweep repeat at fixed time interval (Interval Time)
● Power measurement (Power Monitor)
● Multi-mode fiber mode (MM Mode)
To uses these functions, press
F8
to display the
Measure Mode
and press
F1
.
Measurement modes such as the interval measurement mode, dynamic
range mode, and external trigger mode are displayed in the measurement
settings display field.
Figure 4.7-1 Measurement Settings Field and Power Measurement
Display
External trigger
setting
display
Dynamic range
mode display
Measurement
time interval
Power
Measurement
Display
Multi mode fiber
measurement
indication