Anritsu MS9740B - Appendix C Message List

C-1
Appendix C
Appendix C Message Lists
Table C-1 Error Message List
Message Phenomenon
Auto CAL failed
Automatic wavelength calibration failed due to
changes in temperature and pressure.
Auto Cal in progress
Automatic wavelength calibration is executing.
Auto Measure finished unsuccessfully
Automatic wavelength calibration was not
completed successfully.
Auto-measuring
Automatic measurement is being performed.
Block data error
The binary data format is incorrect.
Calculation enabled only when calculation set
for Trace Type of active trace
An attempt was made to set the calculation
equation when the active trace type is not
Calculate.
Calibrating
Calibration is executing.
Character data error
Some unusable characters are entered.
Character string too long
There are too many characters in the input
string.
Control CPU application error
File not found
A required file was not found.
Control CPU Boot Error
An error occurred during boot processing at
start-up.
Control CPU Shutdown Error
An error occurred during shutdown processing at
power-off.
Copying
An image file is being saved.
Dip point not found
There is no dip point. Check that the input
optical level is sufficient.
Error in Optical Unit
An error occurred in optical unit at start-up.
Either the device has insufficient free space or
the 9999 limit on saved files has been reached.
Either the disk is nearly full and has insufficient
free space or the maximum number of files
(9999) has been saved to disk.
Execution error
An error other than parameter settings occurs.
File already exists. Overwrite?
There is already a file with the same name.
Overwrite the file?
File not found
The file was not found.
File read failed
The file was not read.
File read failed (incorrect model)
There was an error when reading the file
(number conflict).
File read failed (incorrect option configuration)
There was an error when reading the file (option
configuration conflict).
File write failed
The file was not written.
Folder not found
The file was not found.
FPGA Config Error
A FPGA Config error occurred at start-up.
Illegal character in input string
There is a forbidden character in the file name.