Anritsu MS9740B - Page 300

Appendix C Message Lists
C-2
Table C-1 Error Message List (Cont'd)
Message Phenomenon
Input title
There is no file name.
Input the file name.
Input value out of range
The input value is outside the setting range.
Invalid In Sweep-Average
Execution is not supported while the Sweep
Average function is selected.
Invalid wavelength
The input wavelength is out of range.
Item not selected
A file is not selected for reading at Recall.
Mass storage error
A file operation error occurs.
The following errors occur when the file
operation is performed in the Config:
● no specified driver
● format error
● media file full
● no file
● write-protect drive
No external storage device
There is no external storage device (drive E to Z).
No file selected
No file has been selected for operation.
Operation failed because write protected
Unable to execute operation because the file is
write-protected.
Operation prohibited at Analysis
The operation cannot be executed while the
Analysis function is in use.
Operation prohibited at Auto search threshold.
Change search threshold from auto to manual.
The operation cannot be executed while the
Search threshold is Auto. Change the Search
threshold from Auto to Manual.
Operation prohibited at Calibration.
The operation cannot be executed while
calibration is in progress.
Operation prohibited at frequency unit Change
unit from frequency to wavelength.
The operation cannot be executed while the
marker display units are Frequency. Change the
units from Frequency to Wavelength.
Operation prohibited at Linear Scale
Change Linear Scale to Log Scale.
The operation cannot be executed while the level
scale is set.
Change from Linear scale to Log scale.
Operation prohibited at Peak Search and Dip
Search
The operation cannot be executed while Peak
Search and Dip Search are in progress.
Operation prohibited at Wavelength Calibration
Operation prohibited at Auto Alignment
The operation cannot be executed while the
wavelength calibration and auto alignment are
in progress.
Operation prohibited during Auto Measure
The operation cannot be executed while the auto
measurement is in progress.
Operation prohibited during measurement
The operation cannot be executed while the
measurement is in progress.
Operation prohibited when Application selected
The operation cannot be executed while the
application measurement is in progress.