Anritsu MS9740B - Page 301

Appendix C Message Lists
C-3
Appendix C
Table C-1 Error Message List (Cont'd)
Message Phenomenon
Operation prohibited when Area specified as
Noise Detection Type.
The operation cannot be executed while
Detection Type for Noise Parameter is Area
Operation prohibited when Auto Cal is On. Zero
Cal cannot be executed.
The operation cannot be executed while Auto
Cal is On. Zero Cal cannot be executed.
Operation prohibited when Auto PMD selected
The operation cannot be executed while the
PMD setting is Auto.
Operation prohibited when Calculation set for
Trace Type
Change Trace Type to setting other than
Calculation.
The following operations cannot be executed
when Trace Type is set to Calculate.
● Analysis – Spectrum Power display
● Application Analysis function display
Change the Trace Type to some setting other
than Calculate.
Operation prohibited when Overlap is NOT
selected in Storage Mode.
The following operations cannot be executed
when Trace Type is not set to Overlap.
● Erase Overlap
Operation prohibited when Overlap is selected in
Storage Mode.
The following command settings to Active Trace
cannot be executed when Trace Type is set to
Overlap.
● Setting Trace Type to Calculate
Operation prohibited when Normalize Disp
displayed
The operation cannot be executed while
Normalize Disp is displayed.
Operation prohibited when Opt. Amp
Application selected
The following operations cannot be executed
when
F6 Trace
is pressed during optical
amplifier evaluation.
● Active Trace setting
● Trace type setting
● Calculation setting
● Trace display On/Off setting
● Regular /Normalized display switching
Operation prohibited when Peak/Dip Search is
not performed.
Operation is prohibited when either Peak or Dip
search has not been executed.
Operation prohibited when Pulse Method or
WDM Method in Opt. Amp Application is
selected.
Operation is prohibited when either Pulse
Method or WDM Method is selected at the
optical amplifier application.
Operation prohibited when Spectrum Power is
selected.
Operation is prohibited when the spectrum
power is measured using the analysis function.
Operation prohibited when TMkr not displayed
Turn TMkr on.
This operation cannot be performed when trace
mask is not displayed. Set the trace mask
display.
Operation prohibited when WDM Application
selected
This operation cannot be performed while the
WDM test is measured.
Operation prohibited when Zone Marker
displayed Turn Zone Marker off.
This operation cannot be performed while the
zone marker is displayed.
Delete the zone marker.