Anritsu MT8820C - Page 136

136
3.3.2.8. Power Control Absolute power tolerance for CA (intra-band contiguous DL CA and UL CA)
(6.3.5A.1.1)
3.3.2.8.1. MT8820C
This measurement item is not supported by the MT8820C.
Refere to Table 3.3–1.
3.3.2.8.2. MT8821C
This subsection describes an example of intra–band measurement.
[Pass/Fail evaluation limits value setting]
1. Execute TP_PCTABS_TOL 10.0, PCC to set TX3 – Absolute Power (Test Point1/2) Pass/Fail judgment for PCC.
2. Execute TP_PCTABS_TOL 10.0, SCC1 to set TX3 – Absolute Power (Test Point1/2) Pass/Fail judgment for
SCC–1.
[Measurements]
3. Execute TESTPRM TX_PCTABS1 to set Test Parameter toTX3 – Absolute Power (Test Point1).
4. Execute SWP to measure Power Control Tolerance(Absolute Power).
5. Execute PCTPWR? PCC to read the Absolute Power (dBm) measurement result for PCC.
6. Execute PCTPWR? SCC1 to read the Absolute Power (dBm) measurement result for SCC-1.
7. Execute PCTPASS? PCC to check that the Absolute Power measurement Pass/Fail judgment for PCC is Pass.
8. Execute PCTPASS? SCC1 to check that the Absolute Power measurement Pass/Fail judgment for SCC-1 is
Pass.
9. Execute PCTPASS? to check that the Absolute Power measurement Pass/Fail judgment for all CCs is Pass.
10. Execute TESTPRM TX_PCTABS2 to set Test Parameter to TX3 - Absolute Power (Test Point2).
11. Execute steps 4 to 9.
NOTE: The Pass/Fail judgment value for Expected Measured Power differs depending on the Carrier
Frequency f.
f ≤ 3.0 GHz: ≤10.0 dBm (initial value)
3.0GHz < f ≤ 4.2 GHz: ≤10.4 dBm