Programming
71
9. Torque CAM > This is where you define the minimum allowed CAM value. Values
below this minimum value will initiate statistical alarms. See the Statistics
chapter for more information.
10. Torque diff. % < This is where you define the maximum allowed mean difference in per
cent between torque and controller torque. See the statistics chapter for
more information.
3. Use the arrows to highlight (select) the above parameters. You open each
parameter by pressing ‘Enter’.
4. Manually input your preferred values in each parameter. All inputs are
numerical torque values. Press ‘Enter’ to confirm each input.
5. When all parameters have been set according to your preference, highlight
OK and press ‘Enter’ or simply press the ‘OK’ button on the keypad.
Torque setup is now complete and saved and the pop-up dialog box
disappears.
If you need to exit the Torque setup prematurely before setting your preferences
highlight Cancel and press ‘Enter’ or simply press the menu block showing
Cancel. None of the preferences for the above parameters will take effect.
To Next Page
Loading...
