AudioCodes Mediant 500L - Page 102

User's Manual 102 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
The following procedure describes how to configure SNMP v3 users through the Web
interface. You can also configure it through ini file (SNMPUsers) or CLI (configure system >
snmp v3-users).
Note: If you delete a user that is associated with a trap destination (see ''Configuring
SNMP Trap Destinations with IP Addresses'' on page 99
), the trap destination
becomes disabled and the trap user reverts to default (i.e., SNMPv2).
 To configure an SNMP v3 user:
1. Open the SNMPv3 Users table (Setup menu > Administration tab > SNMP folder >
SNMP V3 Users).
2. Click New; the following dialog box appears:
Figure 8-4: SNMPv3 Users Table - Dialog Box
3. Configure the SNMP V3 parameters according to the table below.
4. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
Table 8-3: SNMPv3 Users Table Parameters Description
Parameter Description
Index
[SNMPUsers_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
User Name
username
[SNMPUsers_Username]
Name of the SNMP v3 user. The name must be unique.
Authentication Protocol
auth-protocol
[SNMPUsers_AuthProtocol]
Authentication protocol of the SNMP v3 user.
 [0] None (default)
 [1] MD5

[2]
SHA-1
Privacy Protocol Privacy protocol of the SNMP v3 user.