AudioCodes Mediant 500L - Viewing IP Connectivity

User's Manual 900 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
Registered Per Gateway Registration status of the device as one entity:
 "YES"
 "NO"
Note: The parameter is applicable only to the Gateway
application.
Ports Registration Status Displays the registration status per analog (FXS or FXO)
port:
 "REGISTERED"
 "NOT REGISTERED"
Accounts Registration Status
Displays the status registration per Account, as configured in
the Accounts table (see ''Configuring Registration Accounts''
on page 395).
 Group Type: Served Trunk Group or IP Group
 Group Name: Name of served Trunk Group or IP Group,
if applicable

Status:
"REGISTERED" or "NOT REGISTERED"
Phone Number Status Displays the registration status of BRI endpoints:
 Phone Number: Phone number of endpoint.
 Gateway Port: module/port number of endpoint.
 Status: "REGISTERED" or "NOT REGISTERED"
56.5 Viewing IP Connectivity
You can view on-line, read-only network diagnostic connectivity information on destination
IP addresses configured in the Tel-to-IP Routing table (see ''Configuring Tel-to-IP Routing
Rules'' on page 509).
Note: The table is applicable only to the Gateway application.
 To view IP connectivity status:
1. Enable alternative Tel-to-IP routing that is triggered by connectivity loss with
destination. This is done by configuring the AltRoutingTel2IPEnableparameter to
Enable or Status Only. For more information, see ''Alternative Routing Based on IP
Connectivity'' on page 526.
2. Open the IP Connectivity table (Monitor menu > Monitor tab > VoIP Status folder >
IP Connectivity).
Figure 56-4: Viewing IP Destination Connectivity Status