User's Manual 50 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
6.1.2 Accessing the Web Interface
The following procedure describes how to access the Web interface.
To access the Web interface:
1. Open a standard Web browser.
2. In the Web browser, specify the OAMP IP address of the device (e.g.,
http://10.1.10.10); the Web interface's Login window appears, as shown below:
Figure 6-1: Web Login Screen
3. In the 'Username' and 'Password' fields, enter the username and password,
respectively. The credentials are case-sensitive.
4. If you want the Web browser to remember your username and password, select the
'Remember Me' check box and then agree to the browser's prompt (depending on
your browser). On your next login attempt, the 'Username' field is automatically
populated with your username. Simply press the Tab or Enter key to auto-fill the
'Password' field, and then click Login.
5. Click Login.
Note:
• The default login username and password is "Admin" (case-sensitive). To change
the login credentials, see ''Configuring Management User Accounts'' on page 73.
• By default, Web access is only through the IP address of the OAMP interface.
However, you can allow access from all of the device's IP network interfaces, by
setting the EnableWebAccessFromAllInterfaces parameter to 1.
• By default, autocompletion of the login username is enabled whereby the
'Username' field offers previously entered usernames. To disable autocompletion,
use the WebLoginBlockAutoComplete ini file parameter.
• Depending on your Web browser's settings, a security warning box may be
displayed. The reason for this is that the device's certificate is not trusted by your
PC. The browser may allow you to install the certificate, thus skipping the warning
box the next time you connect to the device. If you are using Windows Internet
Explorer, click View Certificate, and then Install Certificate. The browser also
warns you if the host name used in the URL is not identical to the one listed in the
certificate. To resolve this, add the IP address and host name (ACL_nnnnnn,
where nnnnnn is the serial number of the device) to your hosts file, located at
/etc/hosts on UNIX or C:\Windows\System32\Drivers\ETC\hosts on Windows; then
use the host name in the URL (e.g., https://ACL_280152). Below is an example of
a host file:
127.0.0.1 localhost
10.31.4.47 ACL_280152
To Next Page
Loading...
