AudioCodes Mediant 500L - Message Waiting Indication Parameters

User's Manual 1138 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
service-settings > as-
subs-ipgroupid
[ASSubscribeIPGroupID]
NRT Subscribe Retry
Time
configure voip > gateway
dtmf-supp-service supp-
service-settings > nrt-sub-
retry-time
[NRTSubscribeRetryTime]
Defines the Retry period (in seconds) for Dialog subscription if a
previous request failed.
The valid value range is 10 to 7200. The default is 120.
Call Forward Ring Tone
ID
configure voip > gateway
dtmf-supp-service supp-
service-settings > cfe-
ring-tone-id
[CallForwardRingToneID]
Defines the ringing tone type played when call forward notification is
accepted.
The valid value range is 1 to 5. The default is 1.
69.10.5.4 Message Waiting Indication Parameters
The message waiting indication (MWI) parameters are described in the table below.
Table 69-45: MWI Parameters
Parameter Description
Enable MWI
configure voip > gateway dtmf-
supp-service supp-service-
settings > enable-mwi
[EnableMWI]
Enables Message Waiting Indication (MWI).
 [0] Disable (default)
 [1] Enable
Note:
 The parameter is applicable only to FXS interfaces.
 The device supports only the receipt of SIP MWI NOTIFY
messages (the device doesn't generate these messages).
 For more information on MWI, see 'Message Waiting
Indication' on page 579.
MWI Analog Lamp
configure voip > gateway dtmf-
supp-service supp-service-
settings > mwi-analog-lamp
[MWIAnalogLamp]
Global parameter enabling the visual display of MWI.
You can also configure the functionality per specific calls, using
Tel Profiles (TelProfile_MWIAnalog). For a detailed description of
the parameter and for configuring the functionality in the Tel
Profiles table, see 'Configuring Tel Profiles' on page 471.
Note:
 If the functionality is configured for a specific Tel Profile, the
settings of the global parameter is ignored for calls associated
with the Tel Profile.
 The parameter is applicable only to FXS interfaces.
MWI Display
configure voip > gateway dtmf-
supp-service supp-service-
settings > enable-mwi
Global parameter enabling the sending of MWI information to the
phone display.
You can also configure the functionality per specific calls, using
Tel Profiles (TelProfile_MWIDisplay). For a detailed description of