Version 7.2 95 Mediant 500L Gateway & E-SBC
User's Manual 7. CLI-Based Management
7.7 Configuring Displayed Output Lines in CLI Terminal
Window
You can configure the maximum number of lines (height) displayed in the terminal window
for the output of CLI commands (Telnet and SSH). The number of displayed lines can be
from 0 to 65,535, or determined by re-sizing the terminal window by mouse-dragging the
window's border.
To specify the number of displayed output lines:
1. Establish a CLI session with the device.
2. Access the System menu:
# configure system
3. At the prompt, type the following command:
(config-system)# cli-terminal
4. At the prompt, type the following command:
<cli-terminal># window-height [0-65535]
If window-height is set to 0, the entire command output is displayed. In other words,
even if the output extends beyond the visible terminal window length, the --MORE--
prompt is not displayed.
To Next Page
Loading...
