User's Manual 988 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
• Dial: Starts the test call (applicable only if the test call party is the caller).
• Drop Call: Stops the test call.
• Restart: Ends all established calls and then starts the test call session again.
66.3 Viewing Test Call Status
You can view the status of test call rules in the 'Test Status' field of the Test Call Rules
table. The status can be one of the following:
Table 66-2: Test Call Status Description
Status Description
"Idle" Test call is not active.
"Scheduled" Test call is planned to run (according to the 'Schedule Interval' parameter).
"Running" Test call has been started (i.e., by clicking Dial from the 'Action' drop-down list).
"Receiving": Test call has been automatically activated by calls received from the remote
endpoint for the test call endpoint (when all these calls end, the status returns to
"Idle").
"Terminating" Test call is in the process of terminating currently established calls (when Drop
Call is clicked from the 'Action' drop-down list to stop the test).
"Done" Test call has successfully completed (or was prematurely stopped by clicking the
Drop Call from the 'Action' drop-down list).
66.4 Viewing Test Call Statistics
You can view statistical information on the test call.
Note:
• On the receiving side, when the first call is accepted in "Idle" state, statistics are
reset.
• The device also generates CDRs for test calls if you have enabled CDR
generation (see ''Configuring CDR Reporting'' on page 941).
To view statistics of a test call:
1. In the Test Call Rules table, select the required test call row.
To Next Page
Loading...
